|
SELECTION AND PRESENTATION |
|
Papers will be selected for presentation and publication in the CD-ROM of the symposium on the basis of an extended abstract (at least three pages and not more than four pages including equations, figures and/or references).
Abstracts should be submitted in both Word and PDF formats, by email to cht04@cfd.mech.unsw.edu.au.
and acceptance (or otherwise) will be notified by November 1, 2003.
Abstracts should be prepared in accordance with the Instructions to Authors. The work should not have been previously presented or published elsewhere.
After review and correction
(if necessary) of the extended abstracts, authors will be invited to submit full manuscripts,
prepared in accordance with the
Instructions to Authors.
As suitable papers will be submitted to a journal (see
Proceedings) , the usual length limitation will not apply.
Instead, authors may use a typical journal length: up to
the equivalent of about 20-25 single-spaced typewritten pages in total.
This is a rough maximum; papers may be shorter.
Papers should be sent by email in both Word and PDF formats to
Alternatively, and especially if a file containing a paper exceeds about 1 MB, papers may be submitted in the above formats by air mail on a CD or floppy disk, provided it arrives by the specified date to
School of Mechanical and Manufacturing Engineering,
The University of New South Wales,
Sydney, AUSTRALIA, 2052.
At the symposium, keynote lectures will be given orally and all
contributed papers will be given as poster presentations.
Suggestions for the preparation
of posters are offered for guidance.